Captive Nut Pyrangle Picatinny Foregrip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Revision of the Pyrangle foregrip by CaptainSlug.
- Ocena
- 4 / 5
- Polubienia
- 14
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 425
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Pyrangle, but captive nut!
Realistically, this isn't all that important if you have the 10-32 screw fastened properly in the back of the foregrip, but I have blasters that will not prime if that screw is used, so I made this! Still uses that 10-32 screw that a normal pyrangle uses, though its less necessary with this.
requires 3x M3x25mm 2x M3x12 or 14mm, and 5x M3 nuts. I used the kind of M3 screws that you would find in a Worker Seagull, which
The front piece isn't fully tested, so feedback is greatly appreciated. print the main body upright (default orientation) for best durability, making sure to go slow.