Captive Nut Pyrangle Picatinny Foregrip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Revision of the Pyrangle foregrip by CaptainSlug.
- Rating
- 4 / 5
- Likes
- 14
- Downloads
- 54
- Makes
- 0
- Views
- 425
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Pyrangle, but captive nut!
Realistically, this isn't all that important if you have the 10-32 screw fastened properly in the back of the foregrip, but I have blasters that will not prime if that screw is used, so I made this! Still uses that 10-32 screw that a normal pyrangle uses, though its less necessary with this.
requires 3x M3x25mm 2x M3x12 or 14mm, and 5x M3 nuts. I used the kind of M3 screws that you would find in a Worker Seagull, which
The front piece isn't fully tested, so feedback is greatly appreciated. print the main body upright (default orientation) for best durability, making sure to go slow.