UGREEN Nexode 300w USB charger mount/dock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a wall-mountable "dock" or "caddy" that perfectly fits the UGreen Nexode 300w 5-port USB charger.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 189
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a dock/caddy I made to attach to the backside of my bedside table. This lifts up the charger off the ground, resulting in less USB cable length needed. It also has a frame with holes for the cables to slot through, resulting in less stress on the connectors/ports.
I used tree supports for the inside. It's best printed in the supplied orientation - with the cable frame on the bottom, and the screw holes in the air, supported by supports. This alignment will result in stronger screw holes due the orientation of the layer lines, as well as not relying on layer adhesion to support the weight of the charger.
PETG suggested but would probably be fine with PLA or anything else. If using PETG, supports on the inside might be tricky to remove - I used a combination of crushing the supports and snipping them away using pliers, then a sharp knife to remove as much of the top support interface as possible - for the tiny bits I couldnt get to, I used a sanding rod. Once done, the unit fits perfectly and snugly into the unit. There is a cutout on the back for the power cable to enter.