E*Thirteen Chainring Socket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a socket for the chainring locknut on some E*Thirteen cranks. Meant to clamp into a vice.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 100
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a pretty specific print that very few people are likely to need. But just in case, I figured I'd upload it if anyone else needs it!
This is a socket for the chainring locknut on some E*Thirteen cranks. Not 100% sure which exact ones it would be required for, but my 2019 LG1 cranks required it. Saved paying $30 for the special socket for the lock ring. Its meant to be clamped in a vice and then use the crank arm to loosen it.
Note that I've added a test profile to allow you to scale the print to match your printer. It's important to get the socket to fit as close as you can as it needs to withstand a fair bit of force, so the less play the better. The test profile just allows for dialing in the scaling without printing the full print. Dial that in to fit perfect, then apply the same scale to the main print.
I used a custom layer modifier to print the upper socket profile 100% infill to maximize it's strength. The lower portion of the print only needs standard 15%-20% infill. Printed with standard PETG and had no issues.