Center Tip Clipped - Hygrometer Desiccant Module
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a REMIX of TinkrMakr's design to allow the use of the Desiccant module next to the Hygrometer cap.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 502
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I don't know that I'd really say I remixed something here, I just used PrusaSlicer to clip the tip and you can see how in the .3mf file in PrusaSlicer. The 3D image rendered in this post is misleading as the cylinder is actually a negative removing material.
I originally misunderstood how TinkrMakr intended the modules to go together - mistaking the desiccant module for the space module, and vice versa. I noticed something was wrong because the hygrometer would pop out of the cap when using the desiccant module next to the hygrometer. So I clipped the tip of the cone off by ~1.5mm.
Also, I printed a few of these for use with Prusament spools and really liked filling both modules that will fit in the spool with silica - so I've been using the desiccant module as both the desiccant module and the spacer.
Printing setup:
PETG
.20mm Quality
15% infill
3 perimeters and detect thin walls (may not be needed)
No Supports or Brim needed