BTT Eddy adapter for Geeetech A10 (using BLTOUCH screws) _ Mount helper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
To adapt BTT eddy instead of the 3D Touch on a Geetech A10
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I have a Klipperised Geeetech A10 (If needed I can share my Config file)
I replaced my 3DTouch by BTTEddy USB - and wanted a simple adapter - file AdaptEddyGeeetechA10
The adapter will need M3 threaded insert to limit overall size (add M3 thread in the 2 holes)
To make it fit properly and follow BTT tutorial I also added a mount guide (2mm height) allowing to fix the Eddy probe at the correct height / nozzle - you just have to place it under the probe.
And also to determine the offset:
you need to place the adapter under the probe - note X/Y coordinates and tape the guide on the bed, then move the nozzle in order to reach the round hole and note new X/Y valuex that allows to compute the Y and Y offset.
in my case it is:
x_offset: -43.3
y_offset: 3.0
z_offset: 2.0
It may also be used for some Ender or CR10 - similar to Geeetech A10