BTT Eddy adapter for Geeetech A10 (using BLTOUCH screws) _ Mount helper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
To adapt BTT eddy instead of the 3D Touch on a Geetech A10
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 12
- Makes
- 0
- Views
- 128
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I have a Klipperised Geeetech A10 (If needed I can share my Config file)
I replaced my 3DTouch by BTTEddy USB - and wanted a simple adapter - file AdaptEddyGeeetechA10
The adapter will need M3 threaded insert to limit overall size (add M3 thread in the 2 holes)
To make it fit properly and follow BTT tutorial I also added a mount guide (2mm height) allowing to fix the Eddy probe at the correct height / nozzle - you just have to place it under the probe.
And also to determine the offset:
you need to place the adapter under the probe - note X/Y coordinates and tape the guide on the bed, then move the nozzle in order to reach the round hole and note new X/Y valuex that allows to compute the Y and Y offset.
in my case it is:
x_offset: -43.3
y_offset: 3.0
z_offset: 2.0
It may also be used for some Ender or CR10 - similar to Geeetech A10