JetKVM 2U 19-inch rack mount

A modular, 2-part, 2U 19-inch rack mount for the JetKVM. 

I made this model in 2 variants. One with keystone slots and another without them. Ranging from 3 JetKVMs up to 8 JetKVMs per module.

This mount is part of a 19-inch modular rack mount system I designed. You can mix and match the modules with other mounts. Take a look at my models here to find out the other 19-inch mount modules.

Do you like my models? Consider buying me a coffee ;)

Parts

• 2x M2x12mm screws per JetKVM.
• 6x M5 screws (Min size: 10mm, max size: 16mm).
• 6x M5 hex nuts.

JetKVM Assembly instructions

• Remove the two M2 screws from the top of your JetKVM.
• Insert the JetKVM into the mount, and align the screw holes from the mount with the screw holes from the KVM.
• Insert the 2x M2x12 screws and tighten them.

Assembly

OBS.: The modules used in this tutorial are only for illustration purposes, and I'm using it for the whole series. It might not reflect the models you download at this page. 

Since this is a 2U module, it has two connection joints, so it can either take another 2U module, or another two 1U modules. Either way, you'll need 3 M5 screws and 3 M5 hex nuts per joint, totaling 6 of each per 2U.

• To assemble the parts, insert the 6 screws into the Right module.

• Then align it with the Left module.

• After that, insert the hex nuts in the screws, and using a screwdriver or Allen key.

• Tighten the screws until you start feeling resistance and the nuts are securely into place. After that, you can install the mount in your rack.

Print Settings

Rafts:
Doesn't Matter.

Supports:
No.

Resolution:
0.2 or 0.24

Walls/Perimeters:
At least 4.

Infill:
20% or more

Filament:
Any.