Slide on Tpu Bumper for Super Drum 70
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slip on Tpu bumper for the super drum 70 without modifying the original design. Only hardware is string to help hold it.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 35
- Wydruki
- 1
- Wyświetlenia
- 364
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Pretty much an identical print to the original TPU bumper i made, except does not require a different rear to bolt onto. Same few tests completed and shake test, held on so seems alright to me.
Designed with uneven ground in mind, which is why it encompasses the bottom third of the drum.
Only hardware required is:
- Fishing line (or strong tensile transparent string)
You will need to put the bumper on the bottom of the drum, then you can feed the string through gap at the first holes on the top of each side (blue arrow on last image) towards the bottom on the hole where its a sharp acute angle and tie knots after cinching as much as you can. Doing it there is the shortest length and when you slide the string up it will cinch harder. This will “pinch” the sides to the drum and hold onto it, while still being able to slip it on and off for maintenance.
Doesn't look great but for those who don't want to print a different back it works fine.
PLEASE DON'T HAVE A SOOK AT ME BECAUSE THE BUMPER DIDN'T SAVE THE NECK OR DAMAGED YOUR DRUM. THIS IS JUST PEACE OF MIND AND TO HELP MITIGATE DAMAGE TO THE DRUM ITSELF FROM ACCIDENTAL DROPS.
PLEASE USE AT YOUR OWN RISK.
Provided .step files if you want to edit, but they are pretty cactus.
If you are actually competent at CAD please make a better version, this is more just a stop gap for people to use until a better one is made.