1 / 9
Vacuum Tube Simulation | 500W RF Power Amplifier Tube — zdjęcie 1
1 / 9

Vacuum Tube Simulation | 500W RF Power Amplifier Tube

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is part of a project to build a simulated Ham Radio 2KW RF Linear Amplifier.

Ocena
0 / 5
Polubienia
2
Pobrania
14
Wydruki
0
Wyświetlenia
142
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

I am working on a simulated Ham Radio 2000 Watt Linear Amplifier. As part of it I need four simulated 500 Watt RF Power Amplifier tubes. The eventual amplifier simulation will include a box and some controls. Besides simulated an RF amp, it will also operate as a lamp, and will have a microphone and respond to environmental sounds.

The tube envelope is printed in transparent PETG in spiral vase mode on the QIDI Plus-4 using the 0.24mm Draft profile. The cap and mount are printed in PLA using the 0.20mm Standard profile.  The cap (only) needs supports and was printed using tree supports.

The 8-LED Rings were knocked out of round 92-LED units such as this one https://www.amazon.com/WESIRI-WS2812B-Individually-Addressable-Controller/dp/B083W44B8N The caps include shafts for mounting the LED rings.

 

 

Tagi