1 / 11
ATX Case/Bench - Shorter & Lighter — zdjęcie 1
1 / 11

ATX Case/Bench - Shorter & Lighter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Decreased the weight of the base, removed the awful chamfers on the inside, shortened the cable case

Ocena
0 / 5
Polubienia
21
Pobrania
155
Wydruki
0
Wyświetlenia
1387
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

Case was modified, so my PSU would FIT. I printed the original one and oh boy.. The chamfers - WHY? Literally had to cut open the case so my PSU would fit in there. But when I wanted to print another case like that, I started redesigning it. Chamfers are now removed and I made a big hole in the side of the case, just for gigs and laughs. 

The cable case was shortened, because my PC kinda didn't fit in my shelf. And I think I made it a bit thinner, but I'm not sure. Also I shortened the cable case because I didn't need all that space. No really - I could fit another batch of wires in there if I wanted to. 

About the motherboard holder - I would suggest you print the normal original one, because My holder is kinda experimental and stuff. I tried aligning the holes so I didn't need to make new ones, but anyway I ended up making new holes for the GPU holder :)
Also, my version is a stripped version of the original motherboard holders. It fits the 22x22 build volume if you orient it correctly. It fits the microATX motherboard, but in reality it would hold all the ATX sizes. 

It's just the thing if you mount the motherboard lower (on the middle holes), you will probably have to add counterweight to the back of your PC. I have a GTX 1060 and an Atermiter motherboard with kinda a bulky CPU fan. Thankfully, I was using a heavy HDD and a couple of SSDs. The center of gravity was counterweighted, but I needed to mount these bad boys on one disk holder. So after a couple hours of searching I found a super light disk holder, which was designed for HDDs, but with some long screws I was able to mount my SSDs on there too.

By the way I cut the GPU holder with my cutters to have just 2 holes. Because I didn't need all those excess holes.

Other than that, with a little bit of elbow grease and creativity you can achieve a really cool looking PC. (Purple cable case is the old version. Preview photo with a white cable case is the end result)

 

Tagi