Kobra Neo 2 Clean Start/End Script

USE AT YOUR OWN RISK (FOR ANYCUBIC KOBRA NEO 2 ONLY)
This is a replacement Gcode for the initialization and end print script for the Kobra Neo 2. This script changes a few things to prevent initial stringing/leakage and cleans the nozzle pre-print. Instructions at the end of description.

Start Script:

• Rests the nozzle on the silicone wiper mat while heating to prevent leaking.
• Wipes the nozzle first in a circle then on both sides on the wiper, then between the bed and the wiper.
• Runs at rapid off the edge of X then front of Y to prevent stringing on the bed.
• Primes from the very edge of the X, catching any additional leakage on the edge of the bed, at a lower extrusion rate and higher speed to prevent buildup on the nozzle, then rapids off further before starting print.

End Script:

• Lift Z up a little bit extra. (5mm, make sure you have clearance on tall prints).
• Moves X off the build plate.
• Brings Y all the way out so you don't have to pull the bed out manually.

Instructions:

Completely replace the “Machine start G-code” & “Machine end G-code” In the advanced printer settings in the Anycubic Slicer, as shown in the screenshot. Check for obstructions, and check that the nozzle sits close to center on the wiper pad while warming up, if not, check the X axis with Move X, and replace the X value in the “Machine start G-code” where instructed in the Gcode with the proper value.

*Recommended to run a skirt if you need to check Z-Offset before starting print, as this eliminates the flat run on the bed from the back to front of Y.

Set as "no derivatives to protect people from others modifying this and re-uploading broken versions that could damage your printer.