X-shot MPP Stock-ish Looking Frontend
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Another MPP shroud/handguard/frontend, split for assembly.
- Ocena
- 4,857 / 5
- Polubienia
- 70
- Pobrania
- 252
- Wydruki
- 8
- Wyświetlenia
- 1909
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
So, here's another frontend for the XShot Motorized Piston Pump. Took me about 13 attempts, but the geometry of the frontend should very closely match the front end of the body.
The main differences come down to me not really like the continuation of the integrated hand guard on most models, along with the idea of screwing hardware directly to the blaster. This one has six mlok slots, three on each side.
As such, I tried continuing the lines best I could. I also don't have any sort of AMS system, so the color separation is done through multiple smaller pieces. (On the bright side, you save filament!) You probably have to glue the pieces in.
To assemble, twist the barrel collet off, slide on ‘CollectConnector’, and twist the barrel collet back in place to lock it in. Use the top and bottom picatinny rails along with four m3 screws to lock it into place. Do not glue the shroud to ‘CollectConnector’ if you want to remove in the future.
The .step file is included if you want to merge all the pieces together anyways, or just make any other changes. Let me know if there are any glaring problems, but mine turned out fine.
HARDWARE NEEDED
(4) M3 machine screw (at least 6mm in length) OR similar sized imperial screw.
PRINT SETTINGS
Supports are not required; there's a single overhang on ‘CollectConnector’, but its negligible.