Desiccant Spool Container with a twist
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
42% of the surface is non existant. Meaning air flow. Cylinder prints flat. Roll it!
- Ocena
- 4,5 / 5
- Polubienia
- 1149
- Pobrania
- 3170
- Wydruki
- 40
- Wyświetlenia
- 16 793
- Oceny
- 42
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a better desiccant container solution for my cereal box spool containers.
Most models take too long to print and do not have enough holes.
My design is 45% nothing. Meaning holes. Meaning air can flow freely.
It uses 14g of filament and prints in about 1h-1.5h, depending on printer and filament.
The container should fit most spools.
54mm in diameter and 76mm long.
Print settings
I provided OrcaSlicer and PrusaSlicer .3mf files. The way they each handle modifiers is sadly not interchangeable. The modifier (box on cylinder sheet) sets walls to 1 for faster printing.
0.4mm nozzle
0.2mm layer height
I used PLA and PETG so far.
In PETG the first layer was tricky. Had to up the bed temp to 85°, nozzle to 235° and slow down to 30 mm/s for the first layer. Depends also on your print plate. I used a structured carbon plate (see last 2 photos).
Assembling it is easy and takes about 30 seconds. Okay, maybe not the first time. ;)
If you like the model, add a build.
Feedback welcome!