American Morse Equipment Mini-B Paddle Sleeve Case (Updated)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sleeve and sleeve case for the AMI Mini-B paddle.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 55
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Updated Nov 2025 to v1.1. Added some additional clearance for the adjustment screws and made the case wall a little bit thicker.
------
This is a case sleeve for the American Morse Equipment Mini-B sideswiper/single lever paddle. I designed this because I didn't like how easy it was to inadvertently actuate the paddle while holding it (the exposed screws would get squeezed by my hand). This case covers the screws, and increases the diameter to make it easier for those of us with bigger hands to hold comfortably. I also made a case sleeve just for a little extra protection while the paddle is rolling around inside your pack. Note that you must have your lever installed in the “down” position in order for it it to fit into the sleeve case.
The cases are sized for a friction fit, so keep in mind that you may need to up/downsize them a percent or two depending on your printer's tolerances and what material you are using. FWIW, I printed with PLA on a Bambu X1C and everything fits just right.