1 / 4
Octo4A Phone holder to run Octoprint on your Smartphone — zdjęcie 1
1 / 4

Octo4A Phone holder to run Octoprint on your Smartphone

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An adjustable side mount for the Samsung Galaxy A50 so you can run Octo4A and make great timelapses with Octolapse.

Ocena
5 / 5
Polubienia
136
Pobrania
887
Wydruki
10
Wyświetlenia
6666
Oceny
8

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Public Domain

An adjustable side mount for the Samsung Galaxy A50 so you can run Octo4A and make great timelapses with Octolapse. If your phone is in the same dimensional ballpark as the A50, it will probably fit as well. If it doesn't, I've included the STEP-files so you can add your own.

I've included a little tester (Tester.stl) to check if the dimensions are correct, so you don't waste hours of print time for something that doesn't fit.

Requirements

  • 69g of your favourite filament (nice)
  • 2x M4x20mm Bolts
  • 1x M4 Nut
  • 1x M4 Threaded Insert (I used these)*
  • Soldering iron*

*= You could drill a M4 or M5 bolt into the hole to remove the need of threaded inserts, but it would probably make the turn table less adjustable.

Print Settings 

The entire assembly fits onto an Ender 3 v2 bed, but you'd have to print without a skirt (perhaps a smaller skirt would work, but I've not tested that). I printed at a .2mm layer height at 20% infill, but with 3 wall perimeters and only 2 top and bottom layers. The extra wall makes sure the triangles are one solid piece without infills, and add more rigidity where it counts.

License 

CC-0. Attribution is appreciated, but not required.

Tagi