Camping kettle handle (Kayoba, Redcamp)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replace the annoying, slipping insulation sleeve with this minimalistic handle.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 87
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Normally, there is a thin insulation sleeve on the handle. In time the end starts splitting and it is really difficult to tilt the kettle enough to pour water out. It was time for a more permanent solution.
I've printed this handle with PETG and I don't expect the handle to get hot enough to cause problems. Will see in a couple of days when I have a chance to try it for real… I tried it, it works fine :)
I have simply glued the two halves over the original handle.
Before printing I have altered the default bridging angle to avoid long bridges on top of the groove. You can copy what I did or you can rotate the parts on the sheet.
As per licence, you are free to do whatever you want with this model as long as you keep it non-commercial. I've uploaded a STEP file for your convenience too.