1 / 2
Lily58 Tented Case with Palm Rest
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lily58 Tented Case with Palm Rest
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 514
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (14)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (8)Powiązane
This design in based on this design and also inspired by this design.
For assembly, You'll just need some 5 x M2 x 7mm screws per half and preferably a top plate and rubber feet for traction.
I've uploaded with a range of tenting angled from 6 degrees all the way to 35 degrees, but I've only tested my design using the 15 degree model which is shown in the photos
Print Settings
- Printer - Bambu P1S
- Infill - Adaptive Cubic
- Layer Height - 0.12m
- Supports - Yes
Notes:
- Due to the curved nature, the lower the layer height the better. My prints were done with 0.12mm layer height, but you'll probably wanna lean more towards 0.8mm layer height.
- Supports will help with the bridge on the pro micro cover.
- I used adaptive cubic infill at 15%, and I'm pleased with the results. I'd recommend something like adaptive cubic, support cubic, or lightning infill to save on material.
- You can probably adjust the infill percentage to help you achieve a specific sound profile.