Film Development Tank for 135 and 120 film
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix to ease film loading + enlarge to 120 type film
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 232
- Wydruki
- 1
- Wyświetlenia
- 1408
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
MaciaT's developing tank worked really fine for me. It printed watertight in ABS+ without any acetone smoothing.
But I had difficulties loading the film in the dark. A comparison to an old spiral showed that the grooves used to be much less deep. So I adjusted the depth. This allows you to squeese the film just a little bit and let it expand in the groove. That way you can wind the film into the spiral from the core to the outside.
Enlarging the tank by 10mm gives enough room for 120film (62mm max width). A simple spacer between the spirals adjusts their height. I fixed the spiral parts with some tape only, so they can be separated and used for both sizes.
While 250ml of developer are enough for a roll of 135 you will need 350ml for a roll of 120.
Future detail improvements could be: The cap needs a seal to stay watertight when agitating the tank. The joint between the spirals could benefit from thread or click-on mechanism.