1 / 1
.177 / 4.5mm Pellet / diabolo holder, no feet — zdjęcie 1

.177 / 4.5mm Pellet / diabolo holder, no feet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of a model made by @elliesaurus_2358786 . i was annoyed by the tiny feet at the bottom.

Ocena
0 / 5
Polubienia
1
Pobrania
32
Wydruki
0
Wyświetlenia
313
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

This is a remix of a model made by @elliesaurus_2358786 . i was annoyed by the tiny feet at the bottom, making it impossible to print face up. i have removed the feet. the model is otherwise not changed. This is no fault of Ellie, it's just the setup that i use. 

I had some bad quality plastic left over which i wanted to use up for this, but printing it face down, made the pellet holes string and too tight. i have confirmed through fusion360 measurements that the holes are 4.6-4.7mm wide so the model is correct. It's just that i had issues.

 

(note: i have to upload one pic, so that is the original version that i printed face down)