.177 / 4.5mm Pellet / diabolo holder, no feet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of a model made by @elliesaurus_2358786 . i was annoyed by the tiny feet at the bottom.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 32
- Makes
- 0
- Views
- 316
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Public Domain
This is a remix of a model made by @elliesaurus_2358786 . i was annoyed by the tiny feet at the bottom, making it impossible to print face up. i have removed the feet. the model is otherwise not changed. This is no fault of Ellie, it's just the setup that i use.
I had some bad quality plastic left over which i wanted to use up for this, but printing it face down, made the pellet holes string and too tight. i have confirmed through fusion360 measurements that the holes are 4.6-4.7mm wide so the model is correct. It's just that i had issues.
(note: i have to upload one pic, so that is the original version that i printed face down)
