Tea bag dispenser for openGrid and Multiboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for tea bags that uses Multiconnect Rails to be attached to openGrid or Multiboard
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 464
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
There is not much to say I guess. Here's another tea bag dispenser.
This one can be attached in a french cleat way to https://www.printables.com/model/1214361-opengrid-walldesk-mounting-framework-and-ecosystem using either just the Multiconnect pins or in addition with https://www.printables.com/model/1368797-opengrid-multiconnect-rails.
Tea bags have slightly differing formats but the ones I get here (roughly 58 x 64 mm).
I have only tested it with openGrid light but I assume that it works just as well with the regular openGrid and with the https://www.printables.com/model/1105286-multiconnect-rails-for-multiboard to connect to https://www.multiboard.io/.
I am using PLA with sparse infill (20-25%). Most of the model is walls anyway.
You will need support for the rail hook - I had the best result with manual tree support on my K1.
Ah, and you'll need to flip the model to lay flat on the bottom. I might correct that in a future upload for convenience.