1 / 8
Grandma's Favorite Poopcatcher and Nozzlewiper Combo for the Kobra S1 and S1C — zdjęcie 1
1 / 8

Grandma's Favorite Poopcatcher and Nozzlewiper Combo for the Kobra S1 and S1C

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Nozzlewiper for the Poopshoot of the Anycubic Kobra S1 which uses two A1 Mini Wiper and the orginal metal catcher

Ocena
5 / 5
Polubienia
62
Pobrania
221
Wydruki
0
Wyświetlenia
1955
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Vanilla-Klipper: If you are using vanilla Klipper on your S1 and want on this Wiper optimized Wipe logic

let me know, I am using a custom one


Hybrid Design: A1 Mini Silicone & Original Metal Scraper

Hi! After a long development phase and many prototypes, I am excited to share this nozzle wiper with you. It has been thoroughly tested to ensure the best cleaning results for your Kobra S1. 😊


IMPORTANT: Safety Check

Before your first print, please perform a manual check:

  • Ensure the wiper is fully inserted.

  • Verify that there is a gap between the nozzle and the plastic parts to prevent melting.


Printing Instructions

  • Material: I highly recommend PETG, ABS, or ASA. Avoid PLA due to the heat.

  • Supports: Designed to print without supports.

    • Note: If your printer struggles with bridging, please add manual supports.

  • Z-Offset: If you use my print profile, always double-check your Z-offset before starting!


Assembly & Modification

This system combines A1 Mini silicone brushes with the original metal scraper from your S1.

  1. Prepare the Brushes: Both silicone brushes must be shortened in height.

    • Tip: Use the Nozzle thanks to the help of  M4d53 for the perfect height.

    • Trim one brush in length and the other in width by half.

  1. Installation: Glue the silicone brushes in with rubber adhesive or superglue.

  2. Metal Scraper: Insert the metal scraper into the dedicated slot. A drop of superglue ensures it stays put.


Expert Tips: Removal & Maintenance

  • Removing the Original Metal Scraper: To remove the scraper from the stock "poop shoot," apply some Isopropanol to the adhesive area. Let it soak for a while to loosen the glue, then gently pry it off with a spatula.

  • Removing the Entire Unit: 1. Move the heatbed manually until it is slightly underneath the wiper/catcher. 2. Slide a spatula between the bed and the catcher. 3. Slowly manually raise the bed (Z-axis). The bed's movement will safely push the unit upwards and out of its mount.

  • How do I get the metal scraper back ? : lightly warm the metal with a lighter. Once the surrounding plastic softens, you can easily lever the scraper out with a screwdriver.


Credits

Inspired by the great work of:

I hope you are as happy with the results as I am :)


Tagi