1 / 4
Miele Triflex HX1 Floorhead Roller Brush End Door / Hatch Cover — zdjęcie 1
1 / 4

Miele Triflex HX1 Floorhead Roller Brush End Door / Hatch Cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A 3D‑printable replacement end door (hatch cover) for the roller brush assembly of the Miele Triflex HX1 floorhead.

Ocena
0 / 5
Polubienia
0
Pobrania
11
Wydruki
0
Wyświetlenia
329
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Extra note: If you have any tips / comments. Please let me know!

Overview
This part is the little access door at the end of the motorized floorhead on the Miele Triflex HX1 vacuum cleaner. It clips on to hold the roller brush in place and swings open so you can remove the brush roll for cleaning or replacement. If your original plastic door has broken or cracked, this 3D‑printed version is an exact fit and restores full functionality.

This is a replica for the OEM Miele Triflex HX1 floorhead

 

Printing Guidelines (My print)

  • Material: PLA (the only thing I have)
  • Layer height: 0.2 mm
  • Infill: 100% for extra stability
  • Supports: Not needed

 

Installation

  1. Take the Miele HX1 Floorhead
  2. Remove the screws
  3. Take the cover off
  4. Clean if needed
  5. Pinch the connector and pull the door out
  6. Install new door by putting it in
  7. Close it back up

Tagi