EXEN Orca Custom TPU Prints
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here's the collection I'm currently running on my Orcas
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 181
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Everything should be printed out of TPU with supports.
The Buzzer holder is for a Vifly Finder 2
The Capacitor holder fits a 10mm polymer capacitor with a TVS array attached (I use Unicon 1000uF low ESR capacitors with a Fettec spike absorber)
The Front antenna holder holds a thin ELRS antenna, I use HappyModel ones
The O3 holder has a holder for a 2nd ELRS antenna since I tend to run HappyModel EP1 Dual receivers
The RX holder can hold a HappyModel EP1 Dual, or a Radiomaster RP4TD with a bit of heat to let the tpu deform a bit.
The rear pod is designed to hold an XT60-H (the ones with the little flange), and the antenna holder is designed for linear whip antennas.