EXEN Orca Custom TPU Prints
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Here's the collection I'm currently running on my Orcas
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 13
- Makes
- 0
- Views
- 181
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Everything should be printed out of TPU with supports.
The Buzzer holder is for a Vifly Finder 2
The Capacitor holder fits a 10mm polymer capacitor with a TVS array attached (I use Unicon 1000uF low ESR capacitors with a Fettec spike absorber)
The Front antenna holder holds a thin ELRS antenna, I use HappyModel ones
The O3 holder has a holder for a 2nd ELRS antenna since I tend to run HappyModel EP1 Dual receivers
The RX holder can hold a HappyModel EP1 Dual, or a Radiomaster RP4TD with a bit of heat to let the tpu deform a bit.
The rear pod is designed to hold an XT60-H (the ones with the little flange), and the antenna holder is designed for linear whip antennas.