1 / 13
F-111 CSB "SN-6" | Fully 3D Printable Dual 40mm EDF RC Plane — zdjęcie 1
1 / 13

F-111 CSB "SN-6" | Fully 3D Printable Dual 40mm EDF RC Plane

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Flight Proven Fully 3D Printable RC F-111 Dual 40mm EDF Jet with a 1.17 Thrust/Weight Ratio

Ocena
0 / 5
Polubienia
78
Pobrania
470
Wydruki
0
Wyświetlenia
2672
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

This Project contains the files for my “SN-6” F-111CSB Prototype.

It has already been flight tested successfully.

Specifications:

Channels: 3-4
Wing Span: 83cm
Weight: 600g (300g printed parts)
Thrust: 700g
T/W Ratio: 1.17
Battery: 4S 1300mAh LiPo
Engines: 2x40mm X-Fly Galaxy X4 EDF (5000kV)
Servos: 2xGeneric 9g Servo
Flight Time: ~3min
Gyro Required: No

Recommended Print Settings:

Filament: LW-PLA (eg Colorfabb LW-PLA/LW-PLA-HT, eSUN ePLA-LW)
Temp: 230-250C
Flow: 45%-55%
Infill: 4%-6% Gyroid
Speed: 25mm/s-40mm/s
Acceleration: as high as possible to reduce stringing
Line Width: 0.5mm Outer Walls, 0.4mm-0.6mm Infill
Retractions: off
Avoid Crossing Perimeters: on

Required Components:

Carbon Rods: 2x 2x95mm, 1x  3x800mm, 1x 3x480mm
Servos: 2xGeneric 9g Servo
EDFs: 2x 40mm X-Fly Galaxy X4 EDF (5000kV)
ESCs: 2x30A or better (eg Flycolor Francy 2 30A)
Battery: 4S 1300mAh LiPo
Control Linkages: ~400mm
Cover B: 4x 4x8mm Round Magnets
Cover A: 2x bendable steel wire

Notes:

  • The Tailerons are very sensitive in the Pitch axis, but not very effective in the roll axis

  • LiPos bigger than 4S 1300mAh can fit in the model. though it was never tested with a larger battery pack

  • CG marks are found at the bottom of the wing parts

  • The plane flies very fast at full throttle

  • Parts can be printed on an Ender-3 sized printer or larger (220x220x250)

  • all parts can be printed without supports

  • i highly recommend to gain experience by flying other EDF jets before this one. it's not super hard to fly but also not easy

  • i miscalculated the Thrust and therefore Thrust/Weight ratio in the video. it's not 1.67. it's actually closer to 1.17.

Tagi