Fishing Rod Stand for 10 Rods
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fishing Rod Stand for 10 Rods Easy to build. Short BOM
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 599
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an Extrusion based Fishing rod Stand for 10 Rods.
- Easy to print
- Based on 3030 and 1515 Extrusions
- Very short BOM
- No CNC required
Parts are labeled the following
[p] = primary part
[s] = requires supports enabled
[t] = tpu part but can also be normal filament if desired
[a] = part should be aluminium
BOM:
2x 300mm 30x30 Beam
2x 500mm 30x30 Beam
6x 30x30mm End Covers and corresponding screws if needed
2x 88mm 15x15 MakerBeam XL (requires 5mm hole to be drilled in the center)
2X 207mm 15x15 MakerBeam XL (requires 5mm hole to be drilled in the center)
4x 263mm 15x15 MakerBeam XL
8x M3x12 Socket Head Cap Screw
2x M5x16mm Button Head Screw
16x M5x10mm Button Head Screw
4x M5x35mm Hex Bolt
3030 Tnuts
2x 3mm Aluminium Plate in 365x100mm
4x 30x30mm Rubber Feet
Manufacturing settings
Check your tolerances. Parts have .2mm of leeway.
- Print primary parts out of your favorite normal filament.
- Print TPU parts out of 95A or softer if you can or prefer.
- Cut Aluminium plates or get lasered.