1 / 1
Bambu Lab X1C chamber heater and integral fume filter — zdjęcie 1

Bambu Lab X1C chamber heater and integral fume filter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is my rendition of how I added a heater to my printers chamber and made it to also capture the fumes from ABS print

Ocena
0 / 5
Polubienia
2
Pobrania
9
Wydruki
0
Wyświetlenia
300
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Heater/Fan unit used in this project:

https://www.amazon.com/dp/B07F3S2G9Q?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1

Power supply used:

https://www.amazon.com/dp/B097GYGGDY?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3&th=1

Temperature Controller:

https://www.amazon.com/dp/B07R66S8PG?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3&th=1

Heater assembly components were made from ABS material, printed at .2mm Z steps.

Filter material was .2" thick carbon filter material:

https://www.amazon.com/dp/B00L2NZOKK?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

This requires you to cut into the side panel of the printer enclosure in two locations.

This was done after insulating the inner surfaces of the printer enclosure with the typical self-adhesive aluminized fiberglass sheeting.