Bambu Lab X1C chamber heater and integral fume filter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is my rendition of how I added a heater to my printers chamber and made it to also capture the fumes from ABS print
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 9
- Makes
- 0
- Views
- 301
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Heater/Fan unit used in this project:
https://www.amazon.com/dp/B07F3S2G9Q?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1
Power supply used:
https://www.amazon.com/dp/B097GYGGDY?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3&th=1
Temperature Controller:
https://www.amazon.com/dp/B07R66S8PG?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3&th=1
Heater assembly components were made from ABS material, printed at .2mm Z steps.
Filter material was .2" thick carbon filter material:
https://www.amazon.com/dp/B00L2NZOKK?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
This requires you to cut into the side panel of the printer enclosure in two locations.
This was done after insulating the inner surfaces of the printer enclosure with the typical self-adhesive aluminized fiberglass sheeting.