3in Ported Speaker Cabinet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Budget 2 piece speaker cabinet designed to fit the HiVi B3N 3" speaker
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 173
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
This isn't audiophile quality… the speaker is less than $15 dollars. I just wanted to have speakers on a budget that still sounds good. The enclosure/cabinet was designed to fit a HiviB3N 3in speaker (Part # 297-428 from Parts Express). I don't have any holes for terminals to pass through the inclosure, so holes will need to be drilled.
To print, no supports are needed. I would print with 5 perimeters and a 25%. infill. To improve the rigidity, you can add a thin layer of epoxy on the inside facing sides of the parts. The two pieces snap together, but I also used epoxy to make a seal.
Make sure to have some sort of gasket between the speaker and speaker mount to make sure you have an air tight seal.