Kawasaki H1 CDI and Regulator Bracket Plate + Adapter for Ricks Motorsport 26002-044

I bought new replacement CDI and Regulator Rectifier modules from Rick's Motorsports and wanted to sell my original working units, but would be missing the mounting plate. 

https://ricksmotorsportelectrics.com/Aftermarket-Style-Kawasaki-Rectifier-Regulator-10_337

https://ricksmotorsportelectrics.com/New-All-In-One-Kawasaki-H1-CDI-Box-15_215

Decided I should model up a version of the plate that is 3d printable, and also model versions that accommodate the regulator/rectifier without the need for an ugly adapter or drilling. 

Just need to get the bushings for the mounting holes. Part Number 92075-167 and readily available most places. 

There are 3 files each as a different version:

• Stock 2-piece CDI and stock Regulator/Rectifier
• Stock 2-piece CDI and Rick's Regulator/Rectifier
• 1-piece Rick's CDI and Rick's Regulator/Rectifier
   

All stock equipment and you can print this out, just need to get the bushings Part Number 92075-167 and readily available most places. 

I would suggest printing these in PETG at a minimum. Should be shielded from light and too much heat, but its an old two stroke, so it'll vibrate. I may print these out of PETG-CF or PA6 later. 

There are pockets for M6 and M5 Nylock nuts, hopefully omitting the need for lock washers. 

The stop light dohickey is held on with a zip tie. 

For my PoC prints I used Sunlu PETG, 4 walls , 20% Gyroid Infill, Tree supports with .2 spacing, .2 and .16 layer spacing both work fine. Ironing will make it look nicer, but you wont really see it ideally. 

I should think this would benefit from 100% infill. 

Let me know if you need something or have actually used this.