IKEA TRADFRI Motion Sensor Angled Corner Mount and AAA tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hacked together AAA battery tray and angle mount for a IKEA TRADFRI AAA mount
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 114
- Wydruki
- 2
- Wyświetlenia
- 1799
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I hacked these parts together as I needed a battery tray and an angled corner mount for my IKEA TRADFRI motion sensor
This is the AAA conversion mount. My tray fits inside the mount. Wire the batteries in series so you get +3 Volt.
https://www.thingiverse.com/thing:5156127
This is a dirty hack but works. I removed the top screw hole from the adapter and added screw holes for the angled corner. This is done in the .3cmf file. Warning, only one screw hole aligns as spaced them 15mm from the center of the part.
I soldered a connector to the terminal but you may be able to use this instead
https://www.thingiverse.com/thing:5151225
I'll post an alternative model on PrusaPrinters once my second sensor shows up.