IKEA TRADFRI Motion Sensor Angled Corner Mount and AAA tray
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hacked together AAA battery tray and angle mount for a IKEA TRADFRI AAA mount
- Rating
- 5 / 5
- Likes
- 34
- Downloads
- 114
- Makes
- 2
- Views
- 1,799
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I hacked these parts together as I needed a battery tray and an angled corner mount for my IKEA TRADFRI motion sensor
This is the AAA conversion mount. My tray fits inside the mount. Wire the batteries in series so you get +3 Volt.
https://www.thingiverse.com/thing:5156127
This is a dirty hack but works. I removed the top screw hole from the adapter and added screw holes for the angled corner. This is done in the .3cmf file. Warning, only one screw hole aligns as spaced them 15mm from the center of the part.
I soldered a connector to the terminal but you may be able to use this instead
https://www.thingiverse.com/thing:5151225
I'll post an alternative model on PrusaPrinters once my second sensor shows up.