Hand Press Die Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
To store your hand press dies (for leatherwork or textile work). M8 top receiver, 19mm base receiver
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 92
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
To store your hand press dies (for leatherwork or textile work). These had an M8 screw bit for the top portion, and a 19mm round bottom portion. (mass produced on amazon, temu, ali express). There are two versions - one with hard-coded 'ears' to help the edges not peel up from the print bed while printing (had to hard code, as my printer bed just barely fit at 270mm wide) - the other version does not have any hard-coded ears.
There is a row that a 10mm label could be printed/applied.
This print requires a 260mm-270mm wide print bed.
I have uploaded STEP and F3D versions to allow easier customizations. Parameter names should be fairly explanatory.
Set your maximum die height in DieMaxHeight
Set your label channel width in LabelChannelWidth
Set your overall compartment diameter in CompartmentDia (mine is a bit tight for the 10mm grommet bottom piece
Set the number of sets to sit side-by side with: CompartmentsLength
You will probably want to keep the CompartmentsDoubleRowsWide at 2 (two sets one on top of eachother, 2 rows each (top/bottom), = 4 rows total
- but to make the overall container narrower on the print bed, you could shrink the LabelChannelWidth, or eliminate it altogether.