USB Hub + Gigabit Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple case for the electronics from Tuxedo Computer's USB to LAN Adapter & Hub
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 132
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
A replacement case for Tuxedo's Computer's USB to LAN & Hub.
The original I had had a minor issue with the RJ45 connector not locking the cable properly.
If you have the same device and the Ethernet cable doesn't lock properly, you can either replace the entire case. Or what's a lot easier, cut a small bit of plastic off of the plastic frame in the original, like I did on the replacment Tuxedo sent me:
I only learned this after breaking the first one of course, so I made a new housing very similar to the original housing.
For printing I used Prusament Glaxy Black PLA. If you chose to use another material, make sure to update the text modifiers in the 3mf file. The print doesn't need any supports.
For assembly the PCB is simply layed into the case and should align with the two pins that stick out. The original strain relief can be tucked into a dedicated slot.
Ideally you want to glue the lid to the bottom part, because when you pull a USB cable out you're effectively pulling against the lid.