Beach Umbrella Drill Tip for 19mm pole
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This remix just resizes the original so that it can fit on a pole with a outer diameter of ~19mm.
- Ocena
- 4 / 5
- Polubienia
- 5
- Pobrania
- 41
- Wydruki
- 1
- Wyświetlenia
- 158
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a resized version of the original that should fit a ~19mm outer diameter pole with a inner diameter of ~18mm. It's a little smaller than that to have some clearance. It should fit on most cheap umbrella's you can get.
I got mine from a budget store (Action) for as little as 5 euro. The existing tip is just hallow plastic that you can rip off with pliers. It fits exactly and I used glue to fix it into place. You can also drill a small hole in the pole and the printed part and use a screw to fix it into place.
Haven't tried to use it yet. But I assume materials that can cope with the outdoor heat on the beach is the better choice here.
Should print fine without supports or a brim. I've printed mine with 25% gyroid infill, but I have not tested it yet outdoors so YMMV.