Y-Splitter Exhaust Duct Valve 4 Inch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Y-Splitter Exhaust Duct Valve 125mm by @DOOM scaled to fit 4 inch duct (O.D. ~3.8"/96.4mm)
- Ocena
- 5 / 5
- Polubienia
- 55
- Pobrania
- 435
- Wydruki
- 1
- Wyświetlenia
- 1749
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
Exhaust duct for my Elegoo Centuari Carbon and painting booth. Needed a solution to split in-line 4" fan to both so I remixed this very good design created by @DOOM.
Each inlet has a check valve with a lever.
OD: 3.8"/96.4mm
Parts Needed: 6mm rod
Installation Instructions:
Print (I use PLA+, 100% line infill and supported, see pics for orientation)
2 x Lever
2 x Valve
1 x Splitter
Measure and cut rod to size so that it passes through both holes of the splitter and through the lever
Clamp the rod in a drill and use the drill to friction fit the part through the holes.