Hi-Lite (Hijinx Lite) Pump for SFI X springs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Get a little more draw out of your lynx without giving up SFI X spring compatibility
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 173
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Add 5 to 10 mm of draw to your X springed Lynx by using a little more of the springs free height. Can't guarantee that X springs won't take a set from the higher max compression over time, so the 5mm extension takes 5mm out from precompression instead to play it safe. Untested for X2 and X1, but X3 is already within a few mm of its solid height with 5mm more compression. Introduces some bumps in the prime due to the extension pushing the plunger catch nut outside of the guide, which could be mitigated.
5% with a 5mm spacer recommended: pulling from precompression may be hurting consistency of the plunger at the end of its stroke, so using only 5mm of additional compression should be more consistent. There isn't enough compression available from an X3 to go much further. X5 also cannot take 5mm of additional compression.
Requires Hijinx catch 1 and plunger tail
https://www.printables.com/model/1093231-hijinx-extended-draw-lynx-remix
Hardware:
(optional) requires the stock plunger guide be trimmed by the amount you extend, or a printed guide
8-6-2025: added printed guide with a chamfer to help guide the stock catch nut transition smoothly into the guide
