1 / 1
Filter housing, 80mm round hose to 4in x 4in x 1.25in filter — zdjęcie 1

Filter housing, 80mm round hose to 4in x 4in x 1.25in filter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Designed for an 80mm ventilation hose to an Osimo A2 Air Purifier format filter.

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
47
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

Printing instructions:

  • PLA should be OK, unless you plan on blowing hot air through it
  • Supports shouldn't be needed for the top and cover
  • Supports may be needed for the housing, but it may be printable without. Check your slicer's suggestions
  • Printed with a 0.4mm nozzle and 0.1mm layer height

Assembly:

  • Check alignment of the lid and main housing before gluing anything
  • Apply superglue to the top of the housing, where the lid contacts it
  • Carefully and quickly attach the lid, being careful to maintain good alignment and not glue your fingers
  • Attach the hose to the round side
  • Insert the filter. The fit should be snug, to ensure air is forced through the filter.
    • If the fit isn't snug, you'll need to adjust the model or make an adapter. I've included an f3d file for your convenience
  • Add the lid

Tagi