1 / 1
Filter housing, 80mm round hose to 4in x 4in x 1.25in filter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed for an 80mm ventilation hose to an Osimo A2 Air Purifier format filter.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 47
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
Printing instructions:
- PLA should be OK, unless you plan on blowing hot air through it
- Supports shouldn't be needed for the top and cover
- Supports may be needed for the housing, but it may be printable without. Check your slicer's suggestions
- Printed with a 0.4mm nozzle and 0.1mm layer height
Assembly:
- Check alignment of the lid and main housing before gluing anything
- Apply superglue to the top of the housing, where the lid contacts it
- Carefully and quickly attach the lid, being careful to maintain good alignment and not glue your fingers
- Attach the hose to the round side
- Insert the filter. The fit should be snug, to ensure air is forced through the filter.
- If the fit isn't snug, you'll need to adjust the model or make an adapter. I've included an f3d file for your convenience
- Add the lid