1 / 3
Filler ring for M33 woodturning lathe tools with insufficient depth of report. — zdjęcie 1
1 / 3

Filler ring for M33 woodturning lathe tools with insufficient depth of report.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A filler ring to make tools with insufficient depth of report fit on an M33 pickup of a woodturning lathe.

Ocena
0 / 5
Polubienia
2
Pobrania
12
Wydruki
0
Wyświetlenia
105
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

To fit properly on an M33 pickup of a woodturning lathe the tool should leave sufficient depth for the 9 mm deep 34 mm diameter report. This condition is not always fulfilled, in particular on tools sold via AliExpress, like this one, in which I found the depth of the report to be only ¼". Therefore the faceplate was stopped by the internal thread of the pickup colliding with the report on the spindle. Using it as it is would damage the lathe spindle.

I therefore made a ring that will hopefully provide sufficient clearance. It has a rim covering part of the outside of the flange so I can fit it on the faceplate permanently with tape or glue.

I printed my 4 mm thick ring in PETG with 10 layers bottom and 10 layers top, 20 total so no infill. 

An OpenSCAD file is also provided.

Tagi