Filler ring for M33 woodturning lathe tools with insufficient depth of report.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A filler ring to make tools with insufficient depth of report fit on an M33 pickup of a woodturning lathe.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 12
- Makes
- 0
- Views
- 105
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
To fit properly on an M33 pickup of a woodturning lathe the tool should leave sufficient depth for the 9 mm deep 34 mm diameter report. This condition is not always fulfilled, in particular on tools sold via AliExpress, like this one, in which I found the depth of the report to be only ¼". Therefore the faceplate was stopped by the internal thread of the pickup colliding with the report on the spindle. Using it as it is would damage the lathe spindle.
I therefore made a ring that will hopefully provide sufficient clearance. It has a rim covering part of the outside of the flange so I can fit it on the faceplate permanently with tape or glue.
I printed my 4 mm thick ring in PETG with 10 layers bottom and 10 layers top, 20 total so no infill.
An OpenSCAD file is also provided.