Reinforced K-Cup Recycler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've been using my K-Cup Recycler v6 daily for months. With frequent use, the bolts would continually twist off…
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 33
- Wydruki
- 2
- Wyświetlenia
- 950
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
I've been using my K-Cup Recycler v6 daily for months. With frequent use, the bolts would continually twist off because I needed to repeatedly tighten the nuts. I finally decided to reinforce them. These bolts and nuts are a little heavier with a coarser thread.
Print Settings
Printer Brand:
FlashForge
Printer:
Creator Pro
Rafts:
No
Supports:
No
Resolution:
200 (.2 mm)
Infill:
15% except for K-Cup_RecyclerNewBottom. Better apply 25% to that one. Be sure to use 3 shells for all.
Filament: Any brand filament PLA Any color filament
Notes:
The only new files are
K-Cup\_RecyclerNewBottom.stl
K-Cup_RecyclerNewMiddle.stl
K-Cup_RecyclerNewTop.stl
K-Cup_RecyclerTopNut.stl (2 needed, of course)
If you can manage to pry apart the glued Retainer and Gripper ring from your existing K-Cup Recycler v6 without damaging them, you only need to reprint the above 4 items to beef yours up.
Listed at Thingiverse as remix of
K-Cup Recycler v6
https://www.thingiverse.com/thing:4683310
NUT JOB | Nut, Bolt, Washer and Threaded Rod
https://www.thingiverse.com/thing:193647
Category: Kitchen & Dining