Paint stick / part clip tray for airbrushing models
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds part clips for airbrushing or spray painting model parts in batches
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 49
- Wydruki
- 1
- Wyświetlenia
- 263
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed to replace a stick clip holder that I'd made out of the end of an old 2x4, and I wanted to share it. The holes are 3.15mm spaced 20mm apart on center. The stand is only 10mm tall — perfect for fitting into a small spray booth. The feet on the bottom help it to sit flat on uneven surfaces, and raise it up just enough to easily grab and move it around with one hand while spraying.
I printed mine with the following:
Filament: Overture matte PLA
Orientation: Flip the model upside down so that the top side is flat on the print bed
Layer Height: 0.2mm
Walls: 3
Wall Printing Order: Inner/Outer/Inner
Infill: 90% lightning infill (you could go lower, I just wanted it to be sturdy)
Supports: None
Ironing: None, the top surface is the bottom surface anyway. I recommend using a nice-looking top surface pattern like Hilbert Curve, but it doesn't really matter.
Print Bed Type: Textured PEI plate
Here's the original Onshape document in case you want/need to make any changes.
https://cad.onshape.com/documents/e01b1a5373f42c59ed2abd15/w/ffbdf2ca637f33b044b180fc/e/f4ce3a816e9bf67fa12de0dd?renderMode=0&uiState=68943702ab2cad3927dba2f7