CrowView Note Pi Zero sled
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A sled for Raspberry Pi Zeros to plug into a CrowView Note
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 131
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Kinda disappointed that they only have a couple of their bridges.
I do a LOT of zero projects, so I made my own. I'm just going to leave a PiZ2 on there to set up all my Zeros. (that way I can do a 64 or 32bit OS. And 64bit really isn't faster, just bigger numbers/larger address space) then swap out the SD card to the final project.
Adding some double back tape (not the foam stuff) under the CrowView side of the cables will help them from sliding when plugging/unplugging. The extra bosses I added if I wanted to add a cable clamp the Pi side.
You might have to trim the cable holder for the strain relief. I print almost exclusively in PETG