Voron 2.4/Trident 3d Printer Day Light Pcb Kit 24v Lamp Bar 27cm mount

This is a rigid mount for a Daylight On A Stick 24V Led Light. My printer can generate significant forces that can cause the led bar, if mounted only by its ends, to vibrate. My solution is to just print out a full length bar support that includes a clip to fasten the led bar securely at the center as well as the ends. As the center of the bar is not drilled I secure it using a 3D printed snap clip to the bar.  The ends of the led bar are attached to the mount with screws. I couldn't resist adding clips to the ends as well. Use them if you want to. I did :-)

https://www.aliexpress.com/item/1005005520265506.html?spm=a2g0o.order_list.order_list_main.196.28bf18025g8fym

The mount first attaches to the 2020 using 3 t-nuts or roll in spring nuts and 3 screws, then the day light on a stick attaches to the mount with 2 inserts and screws. I used M3 4x4 sized inserts and 6mm SH screws.

If you don't have inserts you can use a longer pair of screws.  M3 12mm screws should run it into the holes I added below insert pockets.

Fully engage the clips into the bottom pockets then firmly snap the upper clip edges into position. The tolerances are tight and secure.

Everything printed at once in ABS or ASA with 3 walls, 15% infill, 0.24 layers- 2 top and bottom.

The two mounting eyes on my pair of light bars were 198 mm on center.  To account for shrinkage for my  Polymaker ABS and my printing profile I set the eyes 199 mm apart.  The screws thread into the insert without any trouble. You may need to adjust your slicer settings for your printer and filament brand.

You may also be interested in my other Voron Trident mods shown here or at https://www.printables.com/@JimChristian_3198049  &  https://www.printables.com/@JimChristian_3198049/models  They work well  :-)

Also, if you find value in this, please give it a like. Thanks.