E210/2019+ Corolla MagSafe/Qi2 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A MagSafe/Qi2 mount to replace the OEM wireless charger
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 960
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
A MagSafe/Qi2 mount that replaces the OEM rubber wireless charger pad in the E210/2019+ Corolla with the Premium Package (861C0-12011).
Not designed for the standard package with the storage bin (58839-12090-C0).
From my testing, the magnets in iPhones with MagSafe and Androids with MagSafe-compatible cases interfere with the OEM wireless charger in Toyotas, so it only works well with Android devices with regular cases.
Two Mount Options:
The Anker Zolo variation does not need any adhesive since there is a lower edge below the actual charging surface, which allowed me to design a lip to clamp onto the mount. The Apple variation will require adhesive such as VHB tape since the magnetic ring and the charging surface are both the same height. I stuck with the Anker charger due to this limitation, and the black model blends with the rest of the interior. The Anker Zolo's cable was also tested to be long enough to reach the USB-C port in the center storage compartment.
The mount is not airtight due to the cable of the charger, so I included a ventilated dust tray, which takes the place of the original wireless charger unit, utilizing the original screws.
For a clean, almost cable-free looking interior, I routed the charging cable through the center console, where it can be zip-tied to the OEM wiring harness and plugged into the USB-C port in the center storage compartment. You can either drill a hole in the center storage compartment for an entirely hidden cable look or route it down the bottom side of the center console, then up into the storage compartment, as shown in the pictures.
This model was designed to work with my Wireless Charger Pad Storage Tray.
Material: ASA/ABS/PETG
Resolution: 0.2mm
Walls: 4
Infill 40%
Supports: No
Assembly
- Insert the charger into the mount from the bottom and push the charger into the tabs until they snap in.
- Remove the original rubber pad, and if the adhesive stays on the plastic panel, reuse the adhesive.
- Replace the wireless charger unit with the undertray having the vented side facing the front of the vehicle.