Mazda mx-5 miata pre-facelift NA 1989-1993 top left dashboard custom vent grille gauge holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It was specifically designed to fit MFD15 Gen2 – 52mm gauge with no screws
- Ocena
- 0 / 5
- Polubienia
- 4
- Wydruki
- 0
- Wyświetlenia
- 339
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Standard Digital File License
- It was specifically designed to fit MFD15 Gen2 – 52mm gauge with no screws, instead fitting them in a tight compartment and enclosing the gauge with a cap, leading to no movement.
Since the gauge sits on top of a vent grille, cooling of the plastic follows, as well ventilation in the back.
There is a cut in the bottom for wiring, thus I also removed a bit from the grille.
40mm in lenght, you can remove the screw holders to hold other gauges.
I've printed it in Bambulab PLA matte, added UV protection and it sits just fine.
2. Print it at a degree, where the large area of the holder sits at around 330 degrees. To be fair, the less supports the better, so somewhere around that sits fine.
I used a 1.2mm fine Bambulab basic print profile, outerwall speed at 170mm/s and of course, tree supports.