1 / 2
Knipex Wrench Pliers Holder for Skadis Board — zdjęcie 1
1 / 2

Knipex Wrench Pliers Holder for Skadis Board

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holder for the Knipex Wrench Pliers. Fits IKEA SKADIS pegboard.

Ocena
5 / 5
Polubienia
13
Pobrania
107
Wydruki
2
Wyświetlenia
427
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Best to print with supports, though without supports should be fine too. 

Convenient to use: 
the left side wedge is kept fairly small, so the pliers can be “lifted” upwards of the holder, not just “pulled” towards you.

No further parts needed (i.e. no Skids-T-Nut etc). Works with all 3 sizes of the popular Knipex wrench pliers. Minimalist design to save filament.

The Skadis hooks start at bed-level, so prints without supports should be fine, though not tested.

Has “Knipex” written on the left side and “wrench pliers” written on the base.

Tagi